Mazda3 Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi im new to the site. just got doing my rear break job on my 04 mz3 and now the breaks are hanging up a little. had the rotors turned/ ground installed new oem pads. I think i did every thing i needed to, I cleaned and filed the channels the pads ride in and de-bured the pads lubed everything well. I pulled the parking break lever 10 to 20 times to set the self adjusting calipers went out and bedded the breaks in now the pads and the rotors are making real light contact with each other cant figure it out i adjusted the parking break but no luck. Ant ideas whats wrong?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.