Mazda3 Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
2,619 Posts
with the projector housing, it's not a very good idea to put in higher wattage bulb as the chance to melt your wiring harness is extrmely high dude to the enclosed housing. an aftermarket H7 harness should only cost you 10 bucks, cut the old melted one off and connect the new one with a wire connector which you can purchase at any auto part store, and wrap that with electrical tape. You are set to go.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top