Mazda3 Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
9,388 Posts
would if fit, yes, it's the same engine as the regular 3. it's just not cost effective. you can get more power out of a turbo kit from hiboost or sci and walk ms3's all day.
 

·
Registered
Joined
·
9,388 Posts
nobody here has done it. the ms3's just came out. it's not going to be cheap. just get a turbo from hiboost, sci, or hass.
 

·
Registered
Joined
·
2,263 Posts
the only upgrades for the speed are turbo's and down....nothing for the manifold. so you'd still be stuck without that. plus you'd have no way of controlling it without an ecu?? i think you need to rethink your plans. if anything, a stage 1 from SCI would be your most cost effective option then.
 

·
Registered
Joined
·
9,483 Posts
Buy a aftermarket turbo, unless you get ahold of a wrecked MS3 and the junkyard was willing to sell.... everything
 

·
Registered
Joined
·
2,263 Posts
you can most likely order a manifold from RMR, as they make one for the CX7. might need to be modded a bit though.

but i repeat, using any oem stuff is just plain stupid as other routes are cheaper and produce better results.
 

·
Registered
Joined
·
1,054 Posts
After couple of years being out,

people will start installing parts from the MS3 on the 3,

the parts are expensive right now..

but eventually will be done

it's just a matter of time
 
1 - 10 of 10 Posts
Top