[TacticalSlurpi]

Hello, first post sorry if this is in the wrong place, but I found a exhaust from a 2012 mazdaspeed 3. I have a 2.3l mazda 3 and I was wondering if it would fit? From what I've seen it will but it has two tips while mine only has 1. sorry to be unclear I don't know much but two of the purple tips instead of one.

 

[TacticalSlurpi]

its a hatch btw

 

[TacticalSlurpi]

its a hatch btw

I would be switching from the stock exhaust to a "Magnaflow axle back exhaust"

 

[theblooms]

As the bodies are very similar from the MS3 to the MZ3, so long as you're good with a welder and a saw, it should fit even if it requires a bit of modification. The pipe connections may not be the same, hence why you may need a welder, but as far as the mounting points to the body, should be very similar. And again, if they aren't perfect, just weld on new brackets, and you're done.

At the end of the day, it's just pipes that you're hanging from the body. If they're even sorta close, you can make them perfect with a welder and a saw.

 

[Downermazda]

It should just bolt right up except a with the dual exit it won’t fit because the bumper doesn’t have the second cut outs. Putting speed mufflers on a NA 3 is pretty common but they have to be the same gen 3. You could probably cut the one side off and just plug that side of the muffler