Mazda3 Forums banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 · (Edited)
hey so I connected my MBC today and having problems where it overboosts to 25 psi + on the lowest settings. The way I have it connected:

Turbo Compressor housing -> bottom of blox mbc ->bottom of wastegate actuator
to side of blox mbc. top of wastegate and solonoid are capped off. The mbc is set to lowest and it overboosts :cry:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.