Mazda3 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just finished dropping in a newer 2.3 in my 3. Fired right up. However it will not shift into gear. FLuids in it, Torque converter and flywheel tight. No nasty sounds and the dash says its in gear. Please help fellas
 

·
Registered
Joined
·
506 Posts
Do you think the shift linkage is binding or there might be a shift lock engaged on the shifter I know that my father's car (2007 Altima) has a shift lock on it which is a little toggle/button on the shift console. Just my .02 hope this helps you can review the diagrams on this website to help you if need be http://www.mazdaclub.net/mz3ws/
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top