Mazda3 Forums banner
41 - 48 of 48 Posts

· Registered
Joined
·
650 Posts
That's a tough call. I like the SP23 badges on the door but I think it might be a bit of overkill to have both SP23 and Axela badges.

Is there somewhere else like the section between the front wheel arch and the door?
 
G

·
i was thinking about putting it on the side skirt towards the rear...

But then pictured that as an overkill as well...

hmmm....

might just leave it on the back... :? :? :?
 

· Registered
Joined
·
520 Posts
Yup, I have held it up just beside the sp23 badging and it looks a little much. Anything more on the side gets a bit rice.

And if we were to replace the sp23 badging - well... it almost makes it seem like a maxx upgrade. So I shall stick to one for now, until someone visually confirms how good it looks with more.

Can almost use the badge to identify forum members! ;) :D
 

· Registered
Joined
·
650 Posts
Here is a question for you guys then...if you are only sticking one on the back is there any chance of buying your spare for my car?
 

· Registered
Joined
·
650 Posts
Out of interest how much did you pay including shipping? I found the Axela badge on ebay for US$25 + shipping.
 

· Registered
Joined
·
650 Posts
That's not too bad because I doubt I can get shipping for less than AU$2 as the US$25 for the badge is about AU$33.
 
41 - 48 of 48 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top