Mazda3 Forums banner
1 - 1 of 111 Posts

· Registered
2,260 Posts
Ok, NooB question here. I'm psyching myself up for this job, just got my plugs per the previous specs on the OEMs. I bought a socket and extension. I don't have a torque wrench. I assume that is a requirement here, i.e. I shouldn't tighten it until it feels tight? I need to go buy a torque wrench and make sure I tighten it to the stated specs?

Probably a dumb question but I just wanted to make sure. Never done this before.
Make it snug then 1/4 turn and ur fine.

Sent from my SGH-I747M using Tapatalk
1 - 1 of 111 Posts