Mazda3 Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have 2008 mazda 3 2.0l 4 spd auto. I felt a wobble so I went to pull over (going 5mph) I hit a huge mud puddle pothole and blew out my back tire. I got a new tire a few hours later, go to start it the battery was dead and wouldn't jump. I got a new battery fired right up - woohoo! I put it in gear and nothing no reverse no drive no manual mode. When swapping batteries the at light came on briefly. I finally got it in gear got down the road and it died, it wouldn't shift past 2nd.

It starts up fine, you can feel it try to engage. The gear indicator on my dash will go 1, 2, 1,2 sometimes 3, and 4 just being in drive but still not moving. I have NO fault codes.....please help me, anyone

Thank you
 

· Registered
Joined
·
65 Posts
I know teacher, I know! I had a similar problem Monday after changing the battery. The battery terminal cables can mess up after changing the battery on a Mazda. If you can put a code reader on it, I bet you will find low voltage codes in the computer.
Welcome to the forum!
 
1 - 3 of 3 Posts
Top