[bani]

Re: GI; Front Lower Control Arm Bushings

if these fit an ms3, i'm in.

 

[bani]

Re: GI; Front Lower Control Arm Bushings

[quote author=bicycle_wreck link=topic=134503.msg2896673#msg2896673 date=1233182560]
Unless your control arms are binding or squeaking, then there is really no point in swapping out the bushings.
[/quote]

no, these should help reduce the EPIC wheelhop from stock MS3 bushings.

 

[bani]

Re: GI; Front Lower Control Arm Bushings

[quote author=bicycle_wreck link=topic=134503.msg2907777#msg2907777 date=1233630483]
[quote author=bani link=topic=134503.msg2907712#msg2907712 date=1233629321]
[quote author=bicycle_wreck link=topic=134503.msg2896673#msg2896673 date=1233182560]
Unless your control arms are binding or squeaking, then there is really no point in swapping out the bushings.
[/quote]

no, these should help reduce the EPIC wheelhop from stock MS3 bushings.
[/quote]

Maybe after a full solid mount setup and traction bars. I would do these as a last resort, but whatever, I drive an MZ3 and the Speed3s obviously have more torque to torture the suspension.

It just seems like people just buy shit because they can, not because it will actually improve the car, you know? That was the inspiration for my earlier post.
[/quote]

it most definitely improves the car. especially mz3.

you're welcome.

so anyway this is not at all, even in the remotest, "just buying shit because you can". this is a real solution to a real problem -- tranny destroying wheelhop of stock MS3s.

anyway it's pretty obvious you aren't intersted in the least in this GB, why piss on the thread for everyone else?

 

[bani]

Re: GI; Front Lower Control Arm Bushings

[quote author=darkstarmotorsports link=topic=134503.msg2907082#msg2907082 date=1233615924]
[quote author=budgy link=topic=134503.msg2907048#msg2907048 date=1233614905]
these will work with both Speed 3's and MZ3's? I will pass on the good word to a few others if they havent seen this yet, if this gets the go ahead consider me in.
[/quote]

They should fit both, but I will check the part numbers to make sure
[/quote]

any confirmation yet?

 

[bani]

so basically its like the engine torque damper. it has to be ms3 specific.

ah well maybe someone else will make ms3 lca bushings. i suspect the market for ms3 bushings is bigger than the mz3 since the wheelhop on the ms3 is severe.