[harm210]

I saw some fogs on ebay for about a bill$ i wanna get them but wouldnt really know how to install is there a walkthrough anywhere bcuz i havent seen one i know ill have to remove the front bumper but from there im kind of lost lol...

any help? thankz in advance...

 

[gar187er]

they probably screw in, youd have to add power viz the fuse box, run it inside to a switch, and then back out to the lights....prob about an hour, hour and half worth of work....

 

[balding geezer]

You don't have to remove the front bumper. Remove the splash shield under the engine and loosen the shields under the front corners of the bumper so you can get access to the area behind the bumper. The factory inserts are held in with one or two screws and some alignment tabs. They pop out easily and the lights snap in just the same.

The wiring is simple enough to understand but getting the wire from the switch through the firewall is physically challenging if you are bigger than a Barbie doll. If I was to do it again I'd just buy the genuine Mazda foglight switch and take advantage of the factory wiring.

 

[harm210]

yea i actually found a how to on it.... im definately buying the OEM ones.. thanks guys

 

[kipper4080]

which how-to did you use?