Mazda3 Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 · (Edited)
Im trying to put in an aftermarket cold air intake and was going to take off the 90° bend right before the air goes into the engine and attach the new intake there but there are a few hoses going into the piece, what are they for and do I need them
Automotive fuel system Motor vehicle Hood Automotive tire Vehicle

Motor vehicle Automotive tire Automotive fuel system Automotive lighting Electrical wiring

Motor vehicle Automotive tire Car Automotive design Automotive exterior
 

· Registered
Joined
·
6 Posts
Discussion Starter · #5 ·
My plan was to take out that bend and out the new intake piping there but as shown in the 3rd photo there is a hose going I to the bend itself and not into the piece next to it
 
1 - 4 of 4 Posts
Top