Mazda3 Forums banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Anyone have both of these? the COBB SRI and the Turbo inlet pipe combo?

I have read about the inlet pipe moving around cause of no flange to mount it with but the ARI does have a mounting point. Does the combo fix the mobing issue? any one have input or thoughts on this subject?
 

·
Registered
Joined
·
688 Posts
I was actually thinking that the lack of a mounting point on the inlet might take some of the stress off of the battery mount where the SRI bracket attaches. There have been reports of that breaking. If the inlet can move, it may absorb some of the movement and prevent that piece from breaking.
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #3 ·
hmm interesting, good point but i would think it depends on how much movement is too much.. and I just realised I put this in the powertrain board and NOT the modifications board.. I am going to repost it there.. I apologize
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top