Mazda3 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
15,654 Posts
You have a couple of options. I personally hate having wires run all over the place, and back when I had lights in my car (rotater up front, strobe in the back) I hard wired them and put switches in. What I would do is wire a new DC power plug into a constant 12v (should be able to find one in the PJB, or if not just run it to the battery..... fused of course). Then run the wire from your LED light behind the dash panels and plug it into the new plug. Not sure what country you're in, but in the US you can get a DC power splitter (one male plug, two female plugs) that's connected by wires from Walmart for about $3. You can just cut off one of the plugs and wire it in to whatever you want.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top