Mazda3 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Hi 98LX,

I think you should - rethink your previous comment ... ???

"RPM would be lower, but you would have to push the accelerator harder ??"

You would use engine torque to maintain the higher gear whilst maintaining the same rpm vs speed figure.

A minor lesson in recipicating engines; "at any time you press the accelerator in the same gear - the RPM will increase - they are connected by an accelerator cable".

Warren
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top