Mazda3 Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
177 Posts
Discussion Starter #1
Does anyone know if the Aem Cold AirIntake /Short Ram for the P5 will work fit the MZ3 or if the one designes specifically for the MZ3 is out yet ?
 

·
Premium Member
Joined
·
779 Posts
I doubt it... the engine on the P5 is different that those being used on the Mz3s... However, I believe that AEM and some other manufacturers have intakes for the Mz6 2.3l that'll be probably be adapted for the Mx3 engine layout.
 

·
Registered
Joined
·
94 Posts
If the MZ6 intake doesn't fit the engine bay, it shouldn't be long before they make it fit, should be a simple conversion for AEM or Injen to do.
 

·
Premium Member
Joined
·
779 Posts
Do you know how much an improvement those modifications give the engine? I know the injen intake had a 22hp increase, but I believe that was for the Mz6s (V6)...
 

·
Registered
Joined
·
1 Posts
normally just around 5-10 hp, with headers, hi-flow cat, and bigger pipes from the cat back, and intake, you should get around 20-25, all crank though, little of that goes to the wheels
 

·
Registered
Joined
·
132 Posts
i would wait for a better intake manifold :twisted:
and not to be anal but i hate when people say headers on a 4cyl :oops: it makes baby jesus cry
 
1 - 9 of 9 Posts
Top