Mazda3 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Stock Issues
    Hi all, "new" Mazda owner here. I bought a 2006 Mazda 3 not long ago. I was decelerating off of the interstate on my way to work, and when I went to downshift the car wouldn't go into the lower gear. I kept the clutch pushed in, and kept trying to get the vehicle to go in gear. The clutch went...
  2. Powertrain 2004-2009 Mazda3
    I just had the clutch replaced on my 2007 Mazda 3 2.3 sport. The mechanic ordered the wrong clutch kit. They ordered a kit for a mazdaspeed3. They installed the plates then realized the bearing wouldn't fit. So they ordered another kit(presumably the correct one) but they only used the bearing...
  3. Stock Issues
    I've recently replaced the brake and clutch master cylinders as well as the clutch master cylinder and I have bled the clutch system- not the brakes yet. However, even after replacing all this in hopes of fixing a clutch pedal that engages far too soon and too slow, very different than how I...
  4. Powertrain for 2010-2013
    As I backed out of my driveway the other day, I accidentally released the clutch with the car in reverse. I heard a snap and now there is a humming noise when the car is running. Any idea what may have broke? Is it safe to drive the car?
  5. Stock Issues
    I am browsing for a new clutch to buy for my Mazda3 and I am not sure what type of flywheel I need for it. The question I had was, do I have a dual-mass flywheel? I have a 2007 Mazda3 2.3L Sedan but I am not sure what type of flywheel I have. My car is stock so I was wondering what comes stock...
  6. Stock Issues
    Just replaced the clutch and rear main seal on my 2005 mazda3 2.3l hatchback and upon turning the key the first time the car started and then bogged down and died. I waited a few minutes and tried again and the same results (it died within 5 seconds of running) and now it just cranks but wont...
1-6 of 6 Results
Top