Looking into getting a new set of wheels for my 2011 hatch
I've heard of people running 18x9.5 and it sitting well
Was curious how 18x10 would sit...
If anyone has photos of their setups Id love to see pictures as well as detail of specs including offset
Gen 1 racelands. No collars in the rear, only spring. Maxed out front.
Slighty rolled fenders
STR 601 18x9.5 +35/30 in the rear
SPC rear camber arms. I think im at -5
So yeah basically 18x9.5 isnt too much of a hassle. I couldnt imagine 18x10. But then again ive seen a gen 2 mazda 3 with side skirts literally on the floor and rolling with 18x10 or 18x11 and stock camber arms. Its just mad fender work man.
Lowest BC height is the lowest I could ever or ever wanted to go. I got stuck once.
Being any lower, or as low in that picture... I wouldn't even be able to make it into work, and our speed bumps really aren't even that huge.
That sucks. Ive never gotten stuck before but i definitely dont plan to try. I do scrape a lot of speed bumps but idk. I check the undercarriage a lot and theres like plastic and metal shields all under it so i assume im fine.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Mazda3 Forums
4.3M posts
249.4K members
Since 2000
A forum community dedicated to Mazda 3 and all Mazda vehicle owners and enthusiasts. Come join the discussion about MazdaSpeed performance, modifications, classifieds, troubleshooting, maintenance, and more!